- Portiers vidéo
- Pièces détachées
- Contrôle d'accès
31 décembre 2017
In this Quick Guide is explained how to install and configure a FERMAX SIP PANEL with a 3CX Server.
SIP Panel has the following default IP address:
IP = 10.100.0.1
Subnet Mask = 255.0.0.0
Using a PC connected to the same network, it is possible to have access to the Panel Webserver using an internet Browser.
It is strongly recommended to use a 3CX server to test the system.
In order to proceed, follow these steps:
NOTE: ID, Extension and Password should be the same as it was previously configured on the SIP Panel. Otherwise, register will not be completed successfully.
7. After click on “Apply” following information will appear:
NOTE: This process can trigger several minutes. If it is so long, Server can be restarted.
If panel and compatible device that will be called (pushbutton = extension) are configured and connected to the system (SIP server), the call will be done with the video and audio after picking up the handset.
The number/tone configured to open the door on the panel will activate the desired relay.
Do not hesitate to get in touch with FERMAX’s After Sales Department if you have any doubt or if you require any further assistance about this device.