- Control de accesos
31 de diciembre de 2017
DUOX is a completely digital system with non-polarized two wire technology. It offers maximum installation simplicity that enables the transmission of all signals: power, audio and data at maximum capacities.
Duox panels will be installed in the access area of the building, and allow communication with residence, door opener function, calls to the guard, etc.
Panels are available in different designs and materials. Three different styles: Cityline, Skyline and Marine.
There are three typical panel types: Digital panels (with digital display), Pushbutton Panels and Direct Panels (Amplifier + Keypad).
Each type of panel has to be configured using a different method, so there are three ways to configure the DUOX Amplifier.
VOICE ASSISTED CONFIGURATION IN BUTTON PANELS:
Amplifier parameters of a DUOX panel with pushbutton modules, have to be configured through a voice assisted guide.
Installer has to follow these steps:
This is the diagram with all the parameters that can be configured.
KEYPAD CONFIGURATION IN DIRECT PANELS:
Amplifier parameters of a DUOX panel with a Keypad module, have to be configured using the keyboard.
To do this it will be necessary to enter into the configuration mode using a programming access code after pressing ‘A’.
To enter on programming: A + 4444 (Default programming access code). If the code is correct it will sound a confirmation code (beep-beep).
After that, the following parameters can be configured:
Introduce the two digits of its position, a beep will be heard and then it will be necessary to enter the desired value (1, 2, 3 or 4 digits, depending on the setting).
If the value is correct it will sound a confirmation tone (beep beep) and the new value will have been saved. If it was incorrect it will sound the error tone (boop).
To leave the programming mode, press ‘A’ when introducing the position number of the menu. It will also automatically exit after 60 seconds without the need to press any key, generating a beep-beep tone.
DISPLAY CONFIGURATION IN DIGITAL PANELS:
Amplifier parameters of a DUOX Digital Panel, have to be configured using the display and keyboard.
Complete programming guide: http://docweb.fermax.com/docs/techchannel/TEX_DISPLAY_DUOX_PROG_GUIDE.pdf
To do this it will be necessary to enter into the configuration mode using a programming access code after pressing ‘A’. To enter on programming: A + AB21AB
(Default programming access code). After that, enter the identification code 19025 (by default).
Select option 2 “CONFIGURATION” using the Keyboard.
Do not hesitate to get in touch with FERMAX’s After Sales Department if you have any doubt or if you require any further assistance about this device.